I am experiencing a problem with my NCE connection to a Pc via a NCE USB / Power Cab Interface.
The set up has been working for several years both at home and at the Club.
The set up is as before but the PC can not find the Interface unit on COM 3. I have tried using the PC trouble shooting,
it find the interface unit hand hold it for a short time then the JMRI PRO PANEL reports an error. The Power Cab works Ok as a loco controller.
Question 1, Has anybody experience this kind of problem, if so how did they cure it?
Question 2 , Is there a way of testing the USB / Interface unit?
I am reluctant to buy a new interface (£40.00) if I can help it.
Powered by IP.Blog (http://www.invisionblog.com)
© Invision Power Services (http://www.invisionpower.com)