Model Railway Forum banner
1 - 1 of 18 Posts

· Registered
2,342 Posts
QUOTE (Richard Johnson @ 3 Nov 2008, 23:07) <{POST_SNAPBACK}>***Hmmm. Are they the small yellow bits on the door in Nicks photo? Its doable in 4mm scale! N will be a challenge though, my smallest drills are 0.3mm!


Hi Richard

Just curious what do you use to drill with a 0.3mm bit , I have seen some PCB drill bits on 3mm shafts designed to fit in Dremmel style tools but they are always a bit pricey . Are there small chucks available to fit a Dremmel?

Regards Zmil
1 - 1 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.