Model Railway Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 ·
Hello all my good and electrically inteligent friends!
Yes I know I am a complete moron who knows nothing about the mysteries of electricity, and obviously I don't know much about good track planning either!
But, what I have arrived at is basically a loop the ends of which come together at a double slip ( the opposite two ends feed two tracks into a terminus)
Of course i blindly conected it all with metal rail joiners!
I have now re-fitted it with insulated joiners, but now I need to wire it so it will work.
So if there is anyone who can give the most simple basic discription of what i need to do, I would be eternally grateful.
And if it is possible to set the correct polarity and points at the same time, in an easy to understand way, then this would be most welcomed too.
Thank you dear friends for your kind understanding.
Duztee.
 

·
Registered
Joined
·
63 Posts
Discussion Starter · #3 ·
Hi Rchard,
Thank you for taking the time to impart your wisdom to a fool.
I am operating a DCC system (far less complicated wiring! )
The slip is an Insufrog type.
Duztee
 

·
Registered
Joined
·
63 Posts
Discussion Starter · #5 ·
Richard,
Once again kindest regards for your time.
I have read the blurb on Auto reversers and agree that it apears so simple even I can probably get it right!
and it is surely easier than making a major track re-plan.
have gone with your advice and ordered the AR version.
thanks once more for making my simple life simple again!
duztee
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top