Model Railway Forum banner
1 - 1 of 7 Posts

· Just another modeller
9,967 Posts
QUOTE (norsk @ 18 Aug 2008, 23:54) <{POST_SNAPBACK}>
Hello Again Fellow Members..
Would appreciate some advice please...I have received quite a lot of advcie as to appropriate solder iron for basic Model Railway work,,i.e. General-wiring (non decoder/Buliding e.t.c.)

I have never soldered before due to bad hands and i am going to give it a try....i was told the ANTEX temp controlled 50watt TCS230E version should fit the bill..

I was intending to buy from FARNEL`S Norwegain site but found it was £78.00
on there which is nearly twice as much as from u.k. so if anyone can advcie where i could buy one from in u.k. then have it sent to Norway would be obliged

also any leads to really top Soldering suppliers (online)

all the very best Steve

***Steve, Antex will supply you direct I think - there are "buy" options on their website.

1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.