Model Railway Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hi, I have had the Bachmann Dynamis Control System for nearly a year now everything was working fine until recently when one loco that hadn't been used for a while refused to move, on trying get it going I have lost control of all my loco's. My question is how do I get them going again?

thanks,

ews66
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #4 ·
Thank you both ozzie21 & zmil for your advice, what I for got to mention is that I have inadvertantly deleted all the loco addresses on the hand control and should have asked how do I get them back. I have tried entering a locos address but nothing has happened.
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #7 ·
Ozzie21, Zmil & Richard,

Thank you all for your quick replies and advice, I think I may discovered the problem the orange & green lights keep flickering whenever I plug the unit in, the hand control looks as though it is working fine but not recognising the loco numbers. I shall be contacting the suppliers tomorrow.

Once again many thanks for your help.

Regards,
Stewart
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top