Model Railway Forum banner
1 - 1 of 1 Posts

· Registered
135 Posts
Discussion Starter · #1 ·

Im having multiple faller problems at once, so i thoght i would keep them seperate.

I am trying to sculpt some test runs of faller road. I have got the straight bits pretty good, using two aluminium strips and a scraper. I just hold the two strips down either side and scrape the stuff in the gap, works really well but Im unsure how to do corners.

How do I do the other bits of road? I have tried just putting a big blob down and scraping it along with a 6 inch long razor blade, whcih kind of works but the surface is very pitted.

How should I go about this?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.