Model Railway Forum banner
1 - 2 of 3 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
I have just got myelf an CS2. Its very nice indeed! But i have a problem. I have calibrated my screen incorrectly, and now i cant 'press' SETUP, because it thinks that the top of the screen is further down...! What to do?! As i cant get to reset it in the software, and there isnt a reset button on the device, what should i do?

Does it reset after a wile without power?

Thanks in advance
1 - 2 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.