Model Railway Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,342 Posts
Hi Billy

Not sure if I'm on the right track with your Loco
but as it is new it may need a little more running in before conversion to DCC , things are probably a little tight in the drive
and the BEMF is trying to compensate

I get the same problem with older loco's that need a new backplate ( so one new bearing that can be tight)
and need to run them for while before pluging the decoder in

hope this helps

Regards Zmil
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top