CML Accessory Decoder
1 - 4 of 4 Posts
QUOTE (TonyDaly @ 3 Mar 2008, 12:43) <{POST_SNAPBACK}>Hello.
Everyone.
I was thinking of using one of these to operate my Peco & Seep point motors with my NCE system.Has anyone used one of these or can anyone suggest a similar type accessory decoder ?
Regards.
Tony Daly.
I use the CML DAC 10 and it works very well with the Peco point motors. It was very easy to set up.
Photo attached to show in use.
![]()
Everyone.
I was thinking of using one of these to operate my Peco & Seep point motors with my NCE system.Has anyone used one of these or can anyone suggest a similar type accessory decoder ?
Regards.
Tony Daly.
I use the CML DAC 10 and it works very well with the Peco point motors. It was very easy to set up.
Photo attached to show in use.
QUOTE (Doug @ 8 Mar 2008, 22:16) <{POST_SNAPBACK}>Is this accessory decoder only for use with Digitrax & LocoNet?
I think that you can use other controllers, but it can also use the LocoNet architecture
I think that you can use other controllers, but it can also use the LocoNet architecture
1 - 4 of 4 Posts
Join the discussion
