Model Railway Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
278 Posts
Discussion Starter · #1 ·
I have the following;

ROCO points Tillig point motors and a LENZ LS150 and am now wondering how they all fit together with the wiring as the Tillig is a different colour to the Roco etc

I am OK with the power bus to the Lenz etc but from then on?
Regards

Anthony
 

·
Premium Member
Joined
·
7,397 Posts
It tells you how to do this on page 9 of the manual. It does, however, refer to Tillig as Pilz.

The motorized point drive from the company Pilz is connected
exactly like a double-coil point drive; no additional diodes are
required:

Connection to LS150: + C -
Cable colours Pilz drive: pink red yellow
 

·
Registered
Joined
·
278 Posts
Discussion Starter · #3 ·
Hi Neil,

Thanks for the info, I also figured out that if I want to polorize the Roco points I would do this with the white, brown and blue of the Tillig/Pilz motor. did you polorize the Tillig points that you use?

Regards

Anthony James
 
1 - 4 of 4 Posts
Top