Model Railway Forum banner

Connecting Tillig PM and LS150

1289 Views 3 Replies 2 Participants Last post by  neil_s_wood
I have the following;

ROCO points Tillig point motors and a LENZ LS150 and am now wondering how they all fit together with the wiring as the Tillig is a different colour to the Roco etc

I am OK with the power bus to the Lenz etc but from then on?
Regards

Anthony
1 - 2 of 4 Posts
It tells you how to do this on page 9 of the manual. It does, however, refer to Tillig as Pilz.

The motorized point drive from the company Pilz is connected
exactly like a double-coil point drive; no additional diodes are
required:

Connection to LS150: + C -
Cable colours Pilz drive: pink red yellow
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top