Model Railway Forum banner

CTElektronik DCX 74 reset help please

1745 Views 6 Replies 4 Participants Last post by  zmil
Hi All,

I have a CTelektronik DCX74 decoder fitted in a loco working well but i cannot reset the decoder to 03 or change the address despite following the instruction i have and a search on the net only show the same directons, i did hear they have the same characteristics as Zimo is this true ?
Any help would be appreciated.
1 - 7 of 7 Posts
Hi Nick

You haven't locked the decoder by any chance?

Regards

Zmil
To reset the decoder to factory settings, set CV1 to 0. See Section 5 of the English instructions for the DCX74 on the CT website (www.tran.at).
QUOTE (zmil @ 15 Jan 2009, 08:34) <{POST_SNAPBACK}>Hi Nick

You haven't locked the decoder by any chance?

Regards

Zmil

Hope i havnt locked the decoder Zmil

Wire up the programme track later and try TWG 's suggestion
See less See more
2
also try programming in a different mode, not sure what system you have but my digitrax can do paged,direct and physical. i struggled with one of their tiny decoders while trying to use paged mode. but i can't remember which one worked cos it was a year ago.
Hi All,
Many thanks for your help
setting CV1 to 0 worked
See less See more
2
Hi Nick

Glad you got it sorted , I put a couple of my loco's in a consist then later had some problems ,till I de-consisted them.


Regards

Zmil
See less See more
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top