Model Railway Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
47 Posts
I am in the process of building an N gauge layout using DCC and I can assure you that there are no problems at all with fitting the new mini decoders in N gauge locos. Fair enough I cheat with some of mine and send them away to be done. But that is just me being lazy.

As far as points go I have opted not to use DCC but operate the points via a bank of Peco passing contact switches with the motors powered by a redundant DCC 15 volt transformer which eliminates the need for CDUs. Operating the points from the DCC controller struck me as being a bit too complicated whilst trying to run two or more trains from the same hand set.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top