Model Railway Forum banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
6,323 Posts
QUOTE (Anthony566 @ 16 Nov 2013, 00:07) <{POST_SNAPBACK}>1.4 meters does not sound right I have used this system for over 2 years with grater range than that, jus make sure it's not to close to a bright light source as this may case an issue, as for the turnout question if they always operate together then just wire them to the same control point, just remember to either reverse the polarity or rotate the point motor so they operate the correct way round.
QUOTE Any further away and the signal is lost.

Did you mention A566, that all your, I/R system was mounted to the ceiling...........
 

·
Premium Member
Joined
·
6,323 Posts
QUOTE (john worley @ 18 Jan 2015, 09:20) <{POST_SNAPBACK}>hi, Looking at ROCO Z21, has anybody bought one, using one, Can you use it with your existing router. dont want to change my french system. john

Z21 Downloads

You might like to follow Kristophers Topic, on the Z21
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top