Model Railway Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Unless you are using loop(s) all you need to do with Horndy DCC in put in the R8232 DCC ELECTRO POINT CLIPS with isolating point on DCC unit requiring a bus then I would imagine that you would connect power on ether split or that a similar component would work.
With reverse loops you need to use the technique explained here.
Using point motors or other similar equipment should not de necessary.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top