Model Railway Forum banner
1 - 1 of 4 Posts

· Just another modeller
9,967 Posts
***Better not to trap wires anywhere. It is a recipe for problems.

Drill a small hole in each chassis half and countersink it with a larger drill. drive in two tiny self tapping steel or brass screws. solder wire to the screw heads.

OR. drill two tiny holes so that a bit of brass rod or heavy copper wire is a very tight fit. Countersink it as above. Drive the rod/wire into the holes and cut off flush with the top of the countersink. solder wire to the copper/brass filling the countersink hole with solder.


1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.