Joined
·
2,342 Posts
Hello and Welcome to the Forum
With DMUs and running on DCC , to have lighting that is independent , so that the Tail lights can be switched off independent of headlights the light s must be wired to different functions.
Not sure about British outline DMU's , But if the DMU has Head and Tail lighting on both ends of one unit then a TCS 4 function decoder (T4X) will do the job if it can physically fit in the DMU
Function 1 -headlights on one end
Function 2 - headlights on the other end
Function 3 Tail lights on one end
Function 4 Tailights on the other end
If the DMU is part of a Pair (lights on each unit , but only on one end)
Then a T1 will do for the powered unit
Function 1 -headlights
Function 2 - Taillights
and a Stationery Decoder (No motor control ) or Fleetlighter decoder on the non powered unit TCS have a FL2
Function 1 -headlights
Function 2 - Taillights
Or use a FL4 and use the extra functions for Internal lighting This is what I did for an unpowered DMU using the DCC Concepts Flicker Free lighting unit -- Details Here
LEDs are the best for lighting , but each must be wired correctly with Resistor in series (1000 Ohm is a safe option)
The Long leg of the LED is connected to the Blue (+ve) wire of the decoder
Hope this helps
Regards
Zmil
With DMUs and running on DCC , to have lighting that is independent , so that the Tail lights can be switched off independent of headlights the light s must be wired to different functions.
Not sure about British outline DMU's , But if the DMU has Head and Tail lighting on both ends of one unit then a TCS 4 function decoder (T4X) will do the job if it can physically fit in the DMU
Function 1 -headlights on one end
Function 2 - headlights on the other end
Function 3 Tail lights on one end
Function 4 Tailights on the other end
If the DMU is part of a Pair (lights on each unit , but only on one end)
Then a T1 will do for the powered unit
Function 1 -headlights
Function 2 - Taillights
and a Stationery Decoder (No motor control ) or Fleetlighter decoder on the non powered unit TCS have a FL2
Function 1 -headlights
Function 2 - Taillights
Or use a FL4 and use the extra functions for Internal lighting This is what I did for an unpowered DMU using the DCC Concepts Flicker Free lighting unit -- Details Here

LEDs are the best for lighting , but each must be wired correctly with Resistor in series (1000 Ohm is a safe option)

The Long leg of the LED is connected to the Blue (+ve) wire of the decoder
Hope this helps
Regards
Zmil