Model Railway Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
just entering the world of dcc, and have purchased a basic hornby controller, having purchased a bachman diesel I have a slight problem when entering the loco. ~At first it doesnt move then it wll move off without lights and carries on moving with the controller speed turned to zero. I discovered that if I hit the red button to stop everything the lights come on and then the loco performs normally, then is perfectly ok. Now each time I switch on I have to go through this procedure. Could any one explain please ?Another loco behaves perfectly normally
 

·
Registered
Joined
·
10 Posts
Discussion Starter · #5 ·
Hi, Guys, thank you for your replies, most informative, as I have not had the system very long I must persivere with it for now, but the intention was to try out dcc before progressing to something better. I intend to carry out the modification sujested , Thank you all for your comments
 
1 - 2 of 2 Posts
Top