Model Railway Forum banner
1 - 1 of 7 Posts

· Registered
2,342 Posts
Hi Poliss

I'm not sure if the MuliMAUS Pro functions are the same as the MultiMAUS as there is noting on the Website to say otherwise.
Version 1.02 MultiMAUS has functions up to F 20 (you need to do a firmware update from V1.02)
As far as I know the MultiMAUS is still being sold with V1.00 firmware. The update fixes problems Programming some decoders and POM with MultiMAUS on the Lenz LZV100
The Lenz LH100 with LZV100 Version 3.6 has 28 functions that can be programmed as latching and non latching (push on push off and momentary contact) Once again you need to do an update of both units (I think it was mentioned in another thread)

There must be other systems (ECos Manual says 20 functions) that access all 28 functions

Hope this helps

Regards Zmil
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.