Model Railway Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5,592 Posts
Hi Peter Richard Willcox here,

try this,
plug in your DT400 directly into the DCS100 command station. Ref page 94 of the DCS100 manual DCS100 option switch setup. Set Ops 5 to closed, then ops 39 to closed, then return your DCS100 to the run state.
This in effect clears the stacks in your command station. Just read the relevant section as detailed and give it a try it normally works for the odd funny thing that you can't work out.
regards
Rich
 

·
Registered
Joined
·
5,592 Posts
Aggggg...... yes your right, if it's a DB150 I'll have to look it up.........my manuals are all packed away ready for a move.

Peter just check what the DB150 manual says the principle will be the same the DB150 has much smaller stacks (20) I
think, you'll have to train your grandson to purge a loco number or address when changing control Ditto for yourself !

should have bought the DCS100 !
regards
 
1 - 2 of 2 Posts
Top