Model Railway Forum banner
1 - 1 of 4 Posts

· Registered
2,342 Posts
Hi Brendan

Welcome to the forum

I had a quick look at the Hornby website and it appears that you can have continuous output from the accessory decoder
but there is no documentation that you can download regarding changing the CV values to adjust it. One would assume
that there would be a manual of some sort that comes with the accessory decoder.

Before committing your Hard earned Money on this have a look at some of the threads on this forum regarding Point and signaling DCC or otherwise -Search for Masterswitch which can be used to operate both point motors and Signals

There are other ways of operating signal lights automatically from the layout without using an output of the accessory decoder

Hope this helps

Regards Zmil
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.