Model Railway Forum banner
1 - 3 of 33 Posts

· Premium Member
3,966 Posts
i think neil should lend it to each of us in turn so we can all make up our own minds!


P.S. excellent review neil and thanks for the pics. good point about the boler hanging inside the curve instead of hanging over the side like the mallets. interestingly i believe the big boy would have hung out much further in real life than the model does because i believe the rear set of drivers was rigid with the boiler, only the front set was articulated. i bleve the bowser model reproduces this but all the other manufacturers kindly made their models s they would actually go round corners.

Please could you post a picture of the coulings between the sections? is there any electrical connection between the parts? does it have seperate decoders in each end both programmed to the same adress?
1 - 3 of 33 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.