Model Railway Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
13 Posts
Darren, all I can find out is as follows.
You should be able to do this, the manual suggests that readout is possible if Railcom is activated?
Or with loco on program track and using Direct Programing Mode.
I would suggest you connect to your PC, and goto http://www.hornby.com/digital
and see if there are any Firmware upgrades. Leon.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top