Model Railway Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
526 Posts
I don't think you can do that Darren. You can scan CV1 for it's value but if you (or anyone else) has loaded a four digit address then CV's 16 and 17 are where that coded address will be. My command station (Digitrax), if you select CV1, it reverts to automatic mode and will accept any adddress you give it.

Then you select that address on the command station.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top