Model Railway Forum banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
743 Posts

·
Premium Member
Joined
·
743 Posts
As a first foray into model railways with simple track work of what sounds like a double track oval with a few points, I would not worry about 00/H0 debate. The difference when it comes to buildings really is very small so unless you are modelling a very specific location, its not a problem.

I am a huge fan of DCC. However, in this case I would recommend starting out with DC to see how you get on. If you wire the layout well (as you should do anyway, for example add more track feeds than the single one recommended by Hornby) then if you do decide to go DCC one day all it will involve is replacing one controller with another.

As a final bit of advice, if you are looking at DCC, avoid the Hornby Select AT ALL COSTS!

Good luck and ask as many questions as you want,

Rob
 

·
Premium Member
Joined
·
743 Posts
QUOTE (davenic @ 26 Mar 2008, 04:10) <{POST_SNAPBACK}>Thank you for all the replies, I'll definitely be looking around for the best deal and seeing how far my money can go.

80class, is there any reference material for wiring up track feeds and extensions? Do you just run leads to parts of your track in series? How many do you'd think I'll need? Do i just solder these leads onto the track?

Any other advice before I fire the first train up?

A very basic description is to run two wires (or bus) under the baseboard for each of your tracks. Connect dropper wires soldered onto the bottom of the rail to the bus wires, the right hand rail to the right hand wire and vice versa.

A quick search of the forum will reveal that this has been discussed quite a few times before. It is very simple and will result in better running no matter if you are using DCC or DC. Another big advantage is that if you do decide to go over to DCC, it will be very easy transition.

Another good source of wiring information is http://www.wiringfordcc.com/ . It may be a bit over the top for what you need right now, but there is a lot of useful information.

Once you have decided on a rough track plan, if you either upload a picture of it of describe it well, we can advise you how best to wire it up to avoid short circuits and so on.

Hope I haven't confused you too much!

Rob
 

·
Premium Member
Joined
·
743 Posts
hi,

Sorry for the delayed response, been quite busy!

Basically you have a double track mainline.

Wiring this for DC will actually be slightly more involved than for DCC, but no harder to understand! You will need four wires running the length of your board following the profile of the track. Two for track A, two for track B. Connect wires soldered onto the base of the track to the appropriate bus wire every meter or so. Basically Track A Rail A will be connect to wire 1 each time. Track A rail B will be connected to wire 2. Track B rail A will be connect to wire 3 and track B rail B to wire 4.

Now, wires 1 and 2 will be connected to DC controller 1 which will control track A. Wires 3 and 4 will be connected to DC controller 2 which will control track B.

If you then wise to go DCC, simple connect wires 1 and 3 to one of the track outputs and wires 2 and 4 to the other.

If you wish to add points in between tracks A and B, simple use insulating rail joiners where the two points meet.

Hope this makes sense,

Rob
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top