[jmp200]

Has anybody fitted a decoder to a Bachman V2
Regards JMP200

 

[jmp200]

Thanks a lot, i will give it a go

 

[jmp200]

Fitting the wires & decoder is ok but my problem now is refitting the coupling rods etc correctly, very time consuming & a lot of patience

 

[jmp200]

Not a lot of success the plastic pins securing the top coupling rod broke. I managed to repair them but it does not run smoothly, the only plus was at least is wasn't a new locomotive.

 

[jmp200]

Thanks I will consider it . I have made use of the decoder in a tender driven Hornby A4, goes fine.