Model Railway Forum banner
1 - 1 of 13 Posts

· Registered
2,342 Posts
Hi Tony

I'm not familiar with the Digitrax system. But I'm sure someone on the forum is.
CV1 can normally only be changed on the "programming track"
Using the ProgA and ProgB outputs of the DCS50
But other CV's can be change in Operations mode (OPS on your display) of the digitrax

Hope this helps
Regards Zmil
1 - 1 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.