Model Railway Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4,545 Posts
If you cannot get an Xuron track cutter, an Xacto razor saw can be used - this also has many uses for other modelling needs. But any kind of saw needs a guide - a piece of 19 by 25mm wood (3/4 by 1 inch) by 50mm (2 inch) long. Two saw cuts are made in one of the longer faces the width of the rails apart. These are placed over the track and the end used as a guide to the saw to keep it square to the rails.

Regards,
John Webb
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top