Model Railway Forum banner
1 - 1 of 1 Posts

· Registered
488 Posts
Discussion Starter · #1 ·
I refer to the Heljan c33 Eastleigh model's sprung buffers. Apparently on my model, the buffers do move in-out, but are sticking some of the time. Is this a general fault with the class 33 or is my 33 at fault and if this be the case - any suggestions to rectify fault
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.