Model Railway Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
214 Posts
One wire should go from one of the armature pickups (the long copper do-dads) to the pin that couples the tender to the locomotive and the other should go to a ground on the tender. Basically the loco is one side of the pick-up and the tender is the other so if you get the connections wrong way round the engine will go in the opposite direction to that set on the controller. I am away for a couple of days but when i get back, if you still need help, i will pull my Hunt class 4-4-0 and check out the wiring on that. I suspect the Schools will be identical.
Jim Theaker
Ontario
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top