Model Railway Forum banner
1 - 1 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·

I'm attempting to design my first 00 layout and being a draftsman would like to use AutoCAD to design the layout and base board in 3D.

However I need the following information to draw the track pieces.

1. The track centres

2. The sleeper centres on straight track.

If anyone can give me this information I would be most appreciated.


1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.