Model Railway Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,150 Posts
QUOTE (Wizard in Oz @ 29 Mar 2009, 14:03) <{POST_SNAPBACK}>Many thanks for the prompt reply 34C. I shall order a 2.5 mm hex nut driver to use on the crank pins. Would you happen to know where I could buy some spare crank pins? They don't appear to be listed as a separate part by Hornby, but as part of the valve gear set.

Hello.
You could try e-bay as there are a lot of Hornby spares usually for sale there.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top