[Brian Considine]

QUOTE (Gary @ 5 Nov 2006, 13:25) <{POST_SNAPBACK}>Do points switch automatically when using a reverse loop module and how does this work to avoid a derailment?

If you only intend to "go round one way" just use a lighly sprung point (such as a Fleischmann or Roco) set to the "entry" & just run through - the extra cost of a decent point is then offset by not having to buy a point motor and/or additiona controller.

regards
Brian

 

[Brian Considine]

You probably could use just the one but only if there was no chance at all of a loco being in each loop at the same time. This would probably require a lot of extra wiring, so best advice would be to use 2 reverse modules.