Model Railway Forum banner

Hornby R1038

1989 Views 1 Reply 2 Participants Last post by  dwb

I have a Hornby R1038 which is a dual track rail with the HM 2000 controller. I have set this up as two ovals - internal and external. When the train is on the internal track, it stops when it gets to the points. On the outer track, it runs fine.

Can anyone advice where I am going wrong?

1 - 2 of 2 Posts
Without a diagram of your circuit and where you have placed the points and power feeds, it is hard to give advice. My suspicion is that the points are cutting off the supply on the inner oval.

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.