Model Railway Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
75 Posts
You can use the Select to control the points (plugged into an accesory controller). But DO NOT connect both to the track. Connect wires straight from the Select track output to the accesory controller track connection.
Be wary of one thing though: On several forums people have commented that the Select resets when trying to throw points through a Hornby points controller. They have put it down to too little power. In this configuration it might be less of a problem as there will be no trains running off the Select at the same time.

Consider using a CDU for your points. I am not using my LS150 any more; I have opted for hardwired switches on a switch box driving a CDU per point.. It works much easier for me.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top