Model Railway Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
6-wheel tender has left and right frames swapped over,resulting in guard irons at the front instead of rear of the tender.I managed to remove them using superglue de-bonder,then reaffixed correctly using MEK.
 

·
Registered
Joined
·
2 Posts
With all the discussion on 6-wh tenders,be aware that there are two different wheelbases,13 ft as done by hornby for use on the eastern and central sections where short turntables were prevalent,and 14 ft in the west.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top