Model Railway Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
149 Posts
Discussion Starter · #1 ·
hi everyone, i was wondering if anyone has tried the above. i'm thinking of getting this decoder with the light signal r406's. my mind has went blank on me the past few days, it would be just a matter of using the direction button or the turnout button. i'm not sure.

thanks for any help

john
 

·
Registered
Joined
·
536 Posts
Hi John
I wasn't aware the new (R8247) accessory decoder had been released as yet?
Their existing one cant be used for colour light signals as it only has a pulsed output suitable for solenoid point motors
 

·
Registered
Joined
·
149 Posts
Discussion Starter · #3 ·
hi brian,

yes appearently hattons have it in stock, raeding more than 10 in stock as usual.

john
 

·
Registered
Joined
·
4,500 Posts
Just got my 2008 Hornby catalogue. It does say that the new (R8247) decoder can be set by varying the CVs to give continuous outputs for turntable operation, lighting etc., so you should be OK.

Regards,
John Webb
 
1 - 4 of 4 Posts
Top