[madon37s]

Hi all,

Yes, I know, long time no see!

I couldn't find an analogue section for my question so I have put it on here....

Ok, I want to build an analogue controller to be able to run in my O gauge loco's that I have acquired over the last year or so but I really need some help on how to wire it all up.

I am using a Gaugemaster T2 transformer which has 2.5 amps which I believe is correct for O gauge loco's. I have even printed off the Gaugmaster GMTFK1-2 instructions but it doesn't tell you how to wire the hand held controller (I am using a Modelex blue one) from the T2 to the HH controller itself.

The HH controller has FOUR wires of which I know TWO go to the track terminals and the other TWO go to the terminals on the T2 transformer but there's my problem! I cannot find anywhere on the net which wires go to where!

Can anyone help please?

 

[34C]

I'd be onto Gaugemaster just as soon as convenient tomorrow morning for their guidance, if you don't luck into someone here who
knows this kit. Their support for their kit has always been good.

 

[madon37s]

I have rung Gaugemaster this morning and spoke to a very helpful chap and I have now built a cased transformer up for my Modelex hand held controller.

I just need to connect it all up to a piece of track to see if it works properly.

Thanks for the suggestion.