[harkins77]

Hi there guys just been running 2 of my chipped locos on my new Dynamis this evening I must admit I was a bit dubious as the majority of my locos are chipped with the dreaded hornby chip but as yet 2 of the locos I have been using are working fine and are keeping all settings that I have programmed into it.

Just one query I have is that 1 of the locos I have ran is the farish 66952 freightliner loco and it runs all be it very poorly and it does not ramp upto the top speed that some of my other farish diesels have. Is there something I have done wrong or does it sound like a fault.

I did try my mainline class 60 first on my layout and at first it was hesitating but after going round with a track rubber it now runs perfectly around all my track even the concreted area.

Any suggestions would be good.

Regards

Kain.

 

[harkins77]

will do doug.

You should still be able to run locos in when connected to dcc shouldn't you.

I must admit the loco was tested and ran ok on dc before it left the shop. So I guess it would point to the chip being at fault.

 

[harkins77]

Hi guys I do have one small question I have no problem running dcc locos on my layout but for some reason there is nothing in the literature on how to run dc locos using the dynamis and what setting I should use. Does anyone know as the website is about as much use as a chocolate fireguard.