Model Railway Forum banner
Cancel

just throughts on points control

1945 Views 13 Replies 5 Participants Last post by  noblenoel, 
noblenoel
2
Have Just bought a ESU decoder and have read through topic on points mainly using Hornby Have been
wondering if you could or need to wire in c d unit ,I propose to use a separate power supply and am using Bachman Dynamis controller which at the moment not getting on to well any advice or comments would be most useful

Noblenoel sorry just a bit slow with some thing ????????



[email protected]
See less See more
Reply
Save
Like
1 - 6 of 14 Posts
noblenoel
2
Thanks ZMIL I am using peco and seep at the present i have D C unit wired into circuit could i use this and how the best way to wire it in like the sound of the master switch any ideal on who supplies it in the UK
regards Noblenoel
See less See more
Reply
Save
Like
noblenoel
Hi Richard thanks for the advice on the use of Master Switch tried Dcc Supplies but are out of stock at the moment but will give it a try later
regards Noel
See less See more
Reply
Save
Like
noblenoel
2
[quote name='Richard Johnson' date='27 Nov 2008, 13:36' post='68849']
*** No problem, always happy to help.


I believe Bromsgrove models and perhaps Euroscale have them ex stock - I certainly shipped more to Bromsgrove only recently. They both give excellent internet service and are both forum members too. Try them but if not, email me off list or PM me please and I can help.

HI RICHARD at last got round to sending for master Switches which I got from Bromsgrove Models . might add very good service too.
Getting back to switches not sure best way to wire using my esu dcc accessory decoder has any one got a wiring diagram or some simple advice
Happy new year all Noel

Its a bit to cold out in the shed now last look was about -1c so came in to send this
See less See more
Reply
Save
Like
noblenoel
Hi Richard thanks for the prompt reply can it be wired with out the opto board and what does it do

Thanks again Noel
See less See more
Reply
Save
Like
noblenoel
2
Hi Richard me again on about points Vi M/S have obtain M/S the older one not the late model but have been trying to fire 2 peco point off of one M/S both work fine on there own but not together not sure if I have wire up wrong or if power supply is not right am using 14 volt d/c unregulated off of a ex controller output and wire in series but they just do not fire I have followed your wiring diagram also they seam to bounce and buss a bit before they stop any help would be great sorry about being a bit of a pain with some thing that should be simple but wiring is still a bit of ????????Know the basics but get a bit lost some times

yours Noel
See less See more
Reply
Save
Like
1 - 6 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Model Railway Forum
A forum community dedicated to Model train and railway owners and enthusiasts. Come join the discussion about collections, displays, models, styles, scales, motors, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
OO Gauge & 4mm Scale DCC On My Layout The Station Concourse Tracks, Layouts & Scenery
Top