Model Railway Forum banner
1 - 1 of 1 Posts

·
is asleep
Joined
·
758 Posts
If your model is Kato 10910 then it is DCC friendly and you could use the plug in Kato decoder as Poliss suggests. But this won't make the lights in the dummy power car work? Kato do an accessory decoder for the other end I think, but according to that website above they're more expensive than the locomotive decoders!!

The other option is to use any N scale decoder such as a TCS M1 and a matching accessory decoder for the other end, but check first that the model hasn't been designed to make this very difficult on purpose by Kato! I think it is just a question of working out which wire should go where, and perhaps being brave enough to rip out the old Kato PCB if needed. You won't know until you look inside. Hope this helps!
 
1 - 1 of 1 Posts
Top