Model Railway Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
89 Posts
QUOTE (Peter_Harvey @ 16 Feb 2007, 08:08) <{POST_SNAPBACK}>I'm sure that some of you guys will have seen this site but for those that havernt.

This chap produces kits of Laser cut piceses so all you have to do is to put them to gether.

http://www.modelengineerslaser.co.uk/index.htm

He has quite a range of parts available on his website. Does anyone have any experience in using his parts?
 

·
Premium Member
Joined
·
3,614 Posts
i dont have any experience of his parts but remember that they are just the frames and the sheets. no fittings.

My experience of laser bcut parts is that they are very accurate but the cut edge is extreamly hard. you may even need to concider anealing the item if it needs altering. i found flame cut items much nicer.

My experiences are not from model railways.

Peter
 

·
Registered
Joined
·
461 Posts
Discussion Starter · #4 ·
Well Peter he has produced some laser cut brass side frames for me for a stainner OO gauge mogul and there bang on size and have only required a little filing on the edges just to square off the metal.

Pete
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top