QUOTE (Mainthreadmartin @ 26 Oct 2006, 12:41) <{POST_SNAPBACK}>Is the problem that because of the base plate I am having to overcome 2 sets of latches : 1 on the base plate and 1 on the point ? Would it be better to mount the point motor below the point to reduce the number of latches i.e resistance ?
Points thrown from a CDU work fine. Can DCC be used to trigger a CDU discharge?
Any assistance greatly appreciated.
Try removing one of the latches. I think instructions are supplied with the baseplates or the motors to do this.
Try using the low power version of the peco motors.
Use accessory decoders that have a CDU built in.
Andrew
Points thrown from a CDU work fine. Can DCC be used to trigger a CDU discharge?
Any assistance greatly appreciated.
Try removing one of the latches. I think instructions are supplied with the baseplates or the motors to do this.
Try using the low power version of the peco motors.
Use accessory decoders that have a CDU built in.
Andrew
