Model Railway Forum banner

lok progammer

980 Views 5 Replies 5 Participants Last post by  Adrian
Hi, I have a Lok programmer and when I want to alter cv's its reading the info on the decoder but saying no decoder in the bottom left hand corner ,but its sill changing cvs also some times I get an error message can't write cv's .I read some where the lead to the computer could be faulty ,any ideas thanks, Jim .
1 - 1 of 6 Posts
Hello Jim,
Sorry you haven’t had any other responses - I’m not a very experienced user of this amazing machine.
However I have borrowed one from a good friend on a couple of occasions and my friend is always at great pains to make sure I take care of the computer cable and never bend it.
So that may be your problem.
I can’t suggest anything else though, sorry.
Good luck,
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.