Model Railway Forum banner
1 - 1 of 17 Posts

· Registered
31 Posts
Discussion Starter · #1 ·
Picked up the new Maunsell brake composite on Saturday (R4320A) and while admiring my new addition noticed an error which is clearly shown on page 70 of the October issue of HM. The hand rail is printed too far up on the corridor glazing. This has been picked up on the RMWeb and Hornby are providing correct glazing if you contact them.

I must also point out an error in the review on page 70 (sorry Mike). The brake composite is a new body tooling and not just different body markings. In comparison with R4305, the brake compartment is shorter and the first compartments larger.


Dave K
1 - 1 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.