Model Railway Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
Dunno what's gone wrong,
hopefully someone on here can help [PLEASE] Fitted a TCS decoder (M1) into a Liliput HOe engine, no problem, nice easy fit
fired her up, no probs' ran her in as per the book,so far so good,
been running her back and forward on my coffee table test track
for the last few days, never a problem. However,
decided today to programme her, now she was running backwards, so I thought OK, change the CV as per TCS destructions, plus set her into the library, trouble is now, she don't go at all
have tried both Roco's reset destructions, ie CV8 set to 8, and TCS reset CV8 set to 2, neither makes the slightest differance, she just sits there looking at me, not moving a muscle


Anyone got any idea on what coould be wrong, what to try, anything [other than a big hammer] is it something I've done and can reset or is it likely to be the decoder or what?

Help


(It's Skorpio here, you guys helped me with how to wire these decoders
trouble is my laptop logged me out and wouldn't let me back on the forum, so I've had to re-register with my Ebay name
)
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #3 ·
Tried resetting the handset as well, still no go, other engines (factory decoder) working a good un, little'un I fiited the first decoder is working, just this one
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top