Model Railway Forum banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
6,202 Posts
Discussion Starter · #1 ·
Hi all,

This afternoon i was fitting a chip and ready to test on the programme track i plugged it up and it lit the display i came back and nothing, i tried plugging it back into the adaptor supplied with it into the shaver socket all i get is the screen lighting just enough to show the model and then it goes out.
I have tried another plug /shaver adaptor and still the same happens any ideas as to what could be the problem
 

·
Premium Member
Joined
·
4,854 Posts
QUOTE (upnick @ 17 Aug 2008, 20:53) <{POST_SNAPBACK}>Hi all,

This afternoon i was fitting a chip and ready to test on the programme track i plugged it up and it lit the display i came back and nothing, i tried plugging it back into the adaptor supplied with it into the shaver socket all i get is the screen lighting just enough to show the model and then it goes out.
I have tried another plug /shaver adaptor and still the same happens any ideas as to what could be the problem


Is there any chance that the shaver socket is only a 110 volt supply ??

Expat.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top