Model Railway Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
141 Posts
QUOTE (Rail-Rider @ 30 May 2006, 13:00) <{POST_SNAPBACK}>I must confess that although I fully understand 'end-off' electrical switching, I am still confused as to how, at the same time, "current can continue to flow", illuminating the remote switches and colour light signals, without flipping the turnout back the way it was before the button was pressed!

The way this system is wired, the only reason the turnout doesn't flip back must be because the total current taken by the lamp in the signal and the lamp in the operating switch is not sufficient to adequately energise the coil.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top