Model Railway Forum banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
6,205 Posts
QUOTE (N Gauge James @ 6 Feb 2009, 19:44) <{POST_SNAPBACK}>Hello all,

So my NCE Powercab arrived in the post today - I've followed the seemingly very simple instructions and connected it to a length of test track as suggested.

I've then installed (I hope correctly) a 6 pin TCS chip in the power car of my Farish Voyager - and nothing's happened. There's no red light on the panel, although the cab powers up no problem.

I thought it might be my installation of the chip, so I removed it and tried the loco on DC. Nothing happened.

Anyone got a solution for me?

Hi James,

Does the cab light up only momentarily ? it did with mine ..... the transformer was faulty i sent it back and got it changed over.

I would be tempted to ring your supplier of it for advice.
 

·
Premium Member
Joined
·
6,205 Posts
Hi James,

Glad you got it sorted out


TCS offfer a no quibble replacement on their decoders if you send it back to the address on the instructions.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top