Model Railway Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
153 Posts
Discussion Starter · #1 ·
Hello all,

So my NCE Powercab arrived in the post today - I've followed the seemingly very simple instructions and connected it to a length of test track as suggested.

I've then installed (I hope correctly) a 6 pin TCS chip in the power car of my Farish Voyager - and nothing's happened. There's no red light on the panel, although the cab powers up no problem.

I thought it might be my installation of the chip, so I removed it and tried the loco on DC. Nothing happened.

Anyone got a solution for me?
 

·
Registered
Joined
·
153 Posts
Discussion Starter · #4 ·
Hi Nick - no the cab seems to be working fine. Not a sausage from the LED on the panel though.

I've just fried my first decoder as well running it on DC, I have no idea how though, I've checked and checked again the diagrams and everything seems to have been installed as it shows.
 

·
Registered
Joined
·
153 Posts
Discussion Starter · #5 ·
QUOTE (BromsMods @ 6 Feb 2009, 20:09) <{POST_SNAPBACK}>Try plugging the PowerCab into the other socket on the front of the panel. I also assume you are using the flat cable NOT the curly cable.

Regards

John R
Bromsgrove Models

I knew it would be simple - thanks John. I hadn't unpacked the box as well as I thought I had, correct cable/correct function.
 

·
Registered
Joined
·
153 Posts
Discussion Starter · #7 ·
Me again - more problems.

I suspected that the first decoder died as it was touching some metal in the chassis, so this one's wrapped up in insulation.

Now all that happens is that the Powercab shorts out whenever I put the loco on the track. Under DC the loco will run perfectly in reverse, but not forwards. What could be the root of this?
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top